U-center tool to set TOPGNSS receiver common setting operations

Use the U-center test evaluation tool to set the common setting operation steps of the TOPGNSS receiver module

2021-09-15 17:37:54 mei 1608

U-center  tool commonly used setting operation steps (this operation is applicable to all TOPGNSS GNSS receivers with 8030 chip design module)

(1) Change the baud rate

(2) Change the refresh rate

(3) Set GNSS mode and select NMEA version

(4) Close and open NMEN data

(5) Save step: After saving, the receiver will save the set mode and work according to the set mode.


U-center tool download:https://www.u-blox.com/zh/ubx-viewer/view/ubloxGnss_sensorDeviceDriver_windows_3264_v2.40.exe?url=https%3A%2F%2Fwww.u-blox.com%2Fsites%2Fdefault%2Ffiles%2FubloxGnss_sensorDeviceDriver_windows_3264_v2.40.exe



Operation interface description:


(1)Steps to change the baud rate of the GNSS receiver:

(2)Steps to change the refresh rate of the GNSS receiver: 10HZ setting

(3)Steps to change the GNSS mode of the GNSS receiver:

(4)Choose NMEA version

(5)Turn off or turn on NMEA data

(6)Save steps

After setting the required working mode, follow this step to save, the data will be saved in the FLASH inside the receiver, and the receiver will work according to the last set and saved parameters.

There are detailed instructions on the operation steps in the U-center tool use help file. For use help, please view the PDF use help file in the installation directory.

首页
产品
联系