GN-2635G

GN-2630G

GN-2630G GNSS module supports GPS GLONASS Galileo for FPV RC racing droneGN-2630G adopts u-b lox-driven multi-constellation GNSS M8030-KT chip design is a synchronous GNSS receiver that can receive an

  • Model:: GN-2630G
  • GNSS Mode:
  • Operating voltage(V):: DC Voltage 3.6V-5.5V, Typical: 5.0V
  • Operating current:: Capture 50mA/5.0V
  • size(mm):: 26*30*8.6mm
  • Weight(g):: 10g
  • Brand:: TOPGNSS
  • NMEA Message:: UBX,NMEA0183 RMC,GGA,GSA,GSV,GLL,VTG
  • Support customization::

GN-2630G GNSS module supports GPS GLONASS Galileo for FPV RC racing droneGN-2630G adopts u-b lox-driven multi-constellation GNSS M8030-KT chip design is a synchronous GNSS receiver that can receive and track multiple GNSS systems.

For more detailed information about NEO-M8N, please check the U-b lox NEO-M8N page

Product features:

UART  output protocol
GNSS multi-mode design, support GPS+GLONASS and GPS+ Beidou Positioning mode switching
Built in FLASH can be configured to save output parameters
Using UBX-8030-KT chip design
6PIN pin pad
Baud rate: 9600 (default)
Location mode: GPS+GLONASS (default)
GPS+BEI DOU mode can be set
UBX-M8030-KT chipset
Frequency:
  GPS: L1, 1575.4200 MHz
  GLONASS: L1, 1602 (k x 0,5625) MHz
  BEIDOU COMPASS: B1, 1561.0980 MHz
  GALILEO E1, 1575.4200 MHz
  QZSS L1, 1575.4200 MHz
Accepts the signals of up to 72 satellites at the same time
Supports AssistNow online / offline,
  SBAS (WAAS, EGNOS, QZSS and MSAS)
Supports NMEA 0183 protocols: GGA, GSA, GSV, RMC, VTG
USB specification 2.0
Auto Baud Rate up to 115200 bps
Update rate:
  Single GNSS: 18 Hz (e.g. GPS solo)
  Multi GNSS: 10 Hz (e.g. GPS + GLONASS)
Sensibility max. -167 dBm
Magnetic, non-slip on the bottom
LED-indicator for GPS-status
Operating temperature: -40 ° C to 80 ° C
Power supply: 5 Volt
Current consumption: max. 50mA
Cold start in ca. 26 seconds
Hot start in ca. 1 second
Positioning accuracy: 2.5 m CEP (Circular Error Probable) and
2 m CEP with SBAS



TOPGNSS GNSS Module GN-2630G Performance

GNSS CHIP

M8030-KT

frequency

L1 GPS 1575.42,GLONASS L10F Bei Dou B1 SBAS L1 C/A:WASS,

protocol

NMEA 0183 v2.3,4.x GPS/QZSS L1 C/A,GLONASS L10F Bei Dou B1 SBAS L1 C/A:WASS,

EGNOS,MSAS , Support Galileo E1B/C. Default GPS+GLONASS mode
Default:GGA,GSA,GSV,RMC Support:VTG,GLL,TXT binary and NMEA Command

Available baud rate

(Default 9600) Can be set 1200,4800,19200,38400,57600,115200 bps

 Receiving channel

72

Sensitivity

Tracking sensitivity:-160Dbm Capture sensitivity:-157dBm

Cold start

29s average

Warm start time

28s average

Hot start time

1s average

Precision

HorizontalPosition:Autonomous<2.5maverage, SBAS < 2.0m average
Velocity: 0.1 m/s
Timepulse signal: RMS 30 ns

maximum height

18000  Meter

Maximum speed

515 m/s

Maximum acceleration

4G

Update frequency

1-10Hz(default1HZ

A-GPS

AssistNow on-line and off-line

Working output level

output level

Output TTL level

Physical characteristics

PIN

6 pin 1.25pitch  GND,VCC3.3-5V.TX.RX.PPS.EN

Dimensions

30mm *26 mm * 8.5mm

Operating Voltage

3.3V-5.0VDC ±5%

weight

8.5g

Connector form

1.25  6 PIN

Cable length:

15 CM

Operating temperature

-40 to 85

Storage temperature

-40 to 85




首页
产品
联系